Lane separation
- Road Studs, LED Road Studs
Road Studs mark lane and bike path separations actively, at ground level.
The planning problem
Painted dividing lines lose their effect at night, in rain and in fog. Wet roads reflect glare, worn markings barely reflect, and headlights do not reach far. Where traffic lanes and bike paths run close together, the separation needs a marking that stays visible under these conditions.
Let the dividing line itself light up.
Road Studs are set flat into the surface and mark the dividing line with their own light. It stays visible at night, in rain and in fog, even where headlights do not reach.
Hardwired variants are supplied through a cable, solar variants need no grid connection. The right variant depends on power supply and load on site; the values are in the data sheets.
Suitable lights
Recommendation
Road Studs
For traffic lanes and bike lane separations in asphalt: Road Studs mark the dividing line actively, at ground level.
Also possible
Paver Lights
On a paved separating strip that is not driven over, Paver Lights fit as well.
View Paver Lights
- Protection category
- IP68, IK10
- Operating temperature
- −25 °C to +85 °C
- Visibility
- up to 1 km (ONE-WAY, TWO-WAY, TWO-WAY S)
Installation in three steps.
Drill, clean and dry the hole
The hole is drilled at the defined location, cleared of drilling dust and fully dried with hot air.
Insert alignment aid and adhesive
The alignment aid aligns the Road Stud. The adhesive is poured in, and the LEDs must be aligned correctly.
Let it cure
Once the adhesive has cured, the alignment aid is removed. Curing time depends on the weather.
Planning documents (18)
- Road Stud ONE-WAY data sheetOpen file
- Road Stud ONE-WAY installation manualOpen file
- Road Stud TWO-WAY data sheetOpen file
- Road Stud TWO-WAY installation manualOpen file
- Road Stud TWO-WAY S data sheetOpen file
- STARWAY data sheetOpen file
- STARWAY installation manualOpen file
- HALO data sheetOpen file
- HALO installation manualOpen file
- Road Stud CROSSWALK data sheetOpen file
- Solar BASIC data sheetOpen file
- Solar BASIC installation manualOpen file
- Solar CONTROL data sheetOpen file
- Solar CONTROL installation manualOpen file
- Solar FORCE data sheetOpen file
- Solar FORCE installation manualOpen file
- Solar PERFORMANCE data sheetOpen file
- Solar PERFORMANCE installation manualOpen file
Start your lane separation project
We advise you on variant, power supply and installation.