Traffic island with cobblestones, three Road Studs set into the tip of the island

Traffic islands and parking

  • Road Studs, LED Road Studs

Road Studs make islands, entrances and driving lanes visible in the dark.

The planning problem

Even properly marked traffic islands are often overlooked or their width underestimated. Low beams pick them up late, concrete gray curbs are hard to see, and reflective strips wear down through rubber abrasion.

Parking areas have the same problem: islands at barriers and pay stations, edges and driving lanes are hard to read at night, and markings on the surface barely work in the dark.

Street with a traffic island at night, a red and white warning sign marking the tip

Mark islands and driving lanes at ground level along their edges.

Road Studs are set along the outer contour and at the tip of traffic islands, in parking areas at islands in front of barriers and pay stations and along the driving lanes. They do not replace signage but add a marking in the surface that is not tied to poles or beacons.

The variant depends on power supply and load on site.

Traffic island at night, a STARWAY glowing at ground level below the direction sign

Suitable lights

  • Recommendation

    Road Studs

    For island edges, entrances and driving lanes in asphalt: Road Studs make them visible in the dark.

    View Road StudsData sheet
  • Also possible

    Paver Lights

    On paved islands, along curbs and on paved parking areas, Paver Lights fit into the paving pattern.

    View Paver Lights
Power supply
Solar
Load capacity
40 t (FORCE: 30 t aluminum, 60 t stainless steel)
Protection category
IP68, IK10
Operating temperature
−25 °C to +85 °C

Installation in three steps.

  1. Drill, clean and dry the hole

    The hole is drilled at the defined location, cleared of drilling dust and fully dried with hot air.

  2. Insert alignment aid and adhesive

    The alignment aid aligns the Road Stud. The adhesive is poured in, and the LEDs must be aligned correctly.

  3. Let it cure

    Once the adhesive has cured, the alignment aid is removed. Curing time depends on the weather.

Installation manuals

Start your traffic island and parking project

Enhance visibility.