
Roundabouts
- Road Studs, LED Road Studs
Road Studs trace the curb, entry and exit at night.
The planning problem
Especially in newly constructed roundabouts, tire marks and chips on the curb of the inner circle bear witness to the numerous accidents involving even drivers familiar with the area. This is caused by the unexpected new traffic situation and by glare from the light islands that are usually located in front of pedestrian crossings.
Make the geometry legible at night.
Road Studs are set into the surface along the curb and the edges of the carriageway. They trace the inner circle, entry and exit, and are used in roundabouts and on traffic islands.
Solar variants need no grid connection, hardwired variants are supplied through a cable. The variant depends on power supply and load on site.
Suitable lights
Recommendation
Road Studs
For an asphalt carriageway, entry and exit: Road Studs trace the curb and the edge of the lane.
Also possible
Paver Lights
Where the inner ring or the central island is paved, Paver Lights trace the circle in the paving.
View Paver Lights
- Power supply
- Solar
- Load capacity
- 40 t (FORCE: 30 t aluminum, 60 t stainless steel)
- Protection category
- IP68, IK10
- Operating temperature
- −25 °C to +85 °C
Example installation
Installation in three steps.
Drill, clean and dry the hole
The hole is drilled at the defined location, cleared of drilling dust and fully dried with hot air.
Insert alignment aid and adhesive
The alignment aid aligns the Road Stud. The adhesive is poured in, and the LEDs must be aligned correctly.
Let it cure
Once the adhesive has cured, the alignment aid is removed. Curing time depends on the weather.
Planning documents (18)
- Road Stud ONE-WAY data sheetOpen file
- Road Stud ONE-WAY installation manualOpen file
- Road Stud TWO-WAY data sheetOpen file
- Road Stud TWO-WAY installation manualOpen file
- Road Stud TWO-WAY S data sheetOpen file
- STARWAY data sheetOpen file
- STARWAY installation manualOpen file
- HALO data sheetOpen file
- HALO installation manualOpen file
- Road Stud CROSSWALK data sheetOpen file
- Solar BASIC data sheetOpen file
- Solar BASIC installation manualOpen file
- Solar CONTROL data sheetOpen file
- Solar CONTROL installation manualOpen file
- Solar FORCE data sheetOpen file
- Solar FORCE installation manualOpen file
- Solar PERFORMANCE data sheetOpen file
- Solar PERFORMANCE installation manualOpen file
Start your roundabout project
Improve safety and guidance in your municipality.



